Wind back ½ the number of counted turns to the centre point. Follow this with 1/2 turn checks winding in one direction every 10 seconds till the engine starts to stumble, at this point then wind back in the opposite direction counting your half turns till it stumbles again. With your idle circuit, start at 1 1/2 to 2 turns out on the mixture screw and then wind your idle screw back to give a very slow idle whilst at operating engine temp with the bike upright. Here’s our simple outline for basic tuning to get you started. If at all in doubt, see your local tuning shop. Remember the tuning order is – idle circuit, then main jet and then finally mid range. Please positively identify your jet type in the jets section, as all jet sales are final with no refunds. Order required jets as your checks tell you. This is perhaps one of the best written book on carb tuning, just ignore the accelerator pump section if using a non pumper carb and remember that the mixture screw is an air screw where as on carbs with the screw located behind the bowl it will be a fuel screw in which case winding out is to make richer not leaner.īy following the procedures in the book you will determine if jets need changing and in what direction. We recommend you down load the HSR tuning books for Harley Davidson. For tuning procedures we have a number of manuals available to the left.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |